A universal swivel mount with two 1/4-20 UNC studs. The central aluminum lever lets you set different angles at each end and lock both stainless steel ball joints in place.
Dual Ball Head Swivel Clamp – Aluminum with 1/4-20 UNC Threads on Both Sides
How the Two Ball Heads Adjust
Loosening the central lever frees both ball heads. Each 1/4-20 UNC stud can tilt on its own, so you can set the angle at one end to suit the mounting surface and aim the other end where you need it. Tighten the same lever to hold both settings.
- Straight. Point both studs outward along the body when the two mounting points line up.
- Angled. Keep one stud in line and tilt the other to meet an angled bracket or aim a sensor.
- Sideways. In the photo, the studs turn roughly at right angles to the length of the body and point to opposite sides. This can help when the mounting points sit to either side of the clamp.
Available travel depends on the direction of tilt and the clearance around the knurled discs, clamp body and attached parts.


Aluminum Body, Stainless Steel Ball Joints
The black anodized aluminum body holds the two stainless steel ball joints. The central lever is also aluminum. The lever clamps the joints in the body after you swivel each end into position.
- Mounting threads. Both ends have male 1/4-20 UNC studs for matching female threads.
- Knurled mounting discs. The textured edges give you a grip when threading the ends into your equipment.
- Central locking lever. A single control holds both ball heads after you set the angles.
Set Up the Mount
Check the Fit Before Ordering
- Thread depth. Check that both threaded holes are deep enough for the studs to seat correctly.
- Working clearance. Allow room for the knurled discs at your chosen tilt and for your hand to operate the lever.
- Load and reach. Share the weight, mounting angle and how far the equipment extends from the joint. The same weight farther out puts more turning force on the clamp.
For another mounting design, see our lever-operated swivel assembly.
Swivel Clamp Questions
Can I set different angles at the two ends?
Yes. Each stud has its own ball head, so the ends can point in different directions. Both joints loosen and lock together through the central lever.
Can I use a 1/4-20 UNC camera or accessory with this mount?
It can thread into a matching female 1/4-20 UNC socket. Check the depth of the socket and the space around it, especially if the housing sits close to the knurled disc.
What should I send for a fit review?
Send a photo, sketch or drawing of both attachment points with the intended angles and the space around the mount. Include the weight and approximate distance from the joint to the equipment’s center of gravity if you have them.
